FIFA LED stadium light smart system supplier in Bolivia
Most of the lamps on the market are LED lights, because of they are more cost-effective, reliable quality, and outstanding environmental protection advantages. It is one of the products promoted by many government departments. However, compared with ordinary halogen lamps, there are some disadvantages, such as relatively high prices. So what are the differences between the two? Will halogen lamps be replaced by LED fixtures?
Compared with halogen, LED has the advantages of accurate color temperature, high luminous efficiency, no pollution, and energy saving. Although the price is still a bottleneck, with the continuous improvement of energy-saving and emission reduction and the continuous improvement of light efficiency requirements, the recognition and acceptance of LED are also increasing. It is an inevitable trend for LED lights to replace halogen lamps, and it is only a matter of time.
Before guiding you to make lighting decisions, we think it is very important to understand the difference between LED lights and standard halogen lamps.
LED: it uses light-emitting diodes to emit light. The principle of light emission is the direct conversion of electricity to light, which is a cold light source.
Halogen: it uses tungsten filaments to emit light. The principle of luminescence is the conversion of electricity-heat-light energy, which is an incandescent light source.
Compared with LED, halogens consume much higher energy. If you want to measure the amount of light emitted by any light source, then technically speaking, a halogen lamp will produce 2,700 lumens, which translates to 30 watts.
On the other hand, when using the same 30 watts of power, the LED light fixture will produce about 4,500 lumens. When the wattage used is the same, the lumens produced by the LED light will be higher than that of the halogen lamp, so the lighting effect of the LED light will be higher than that of the halogen lamp; When the required lumens are the same, the wattage of the LED light will be lower than that of the halogen lamp, so the energy consumption of the LED light will be lower than that of the halogen lamp.
LED lights have a stable life expectancy, can up 50,000--80,000 hours. That is equivalent to around 13 years.
Halogen lamps are affected by its manufacturing process, the life expectancy is far lower than that of LEDs, only 3500-3600 hours, which is equivalent to 1 year.
The CRI of Halogen lamps is 100, and it is identical to the standardized daylight. With the continuous development of technology, the CRI section of LED will be continuously improved, and there are already high CRI and high luminous efficiency lamp beads that can achieve more than 95. In general, the CRI of LED is around 80, and that has reached our requirements for lighting fixtures.
Actually, the important point is CCT, not CRI. When CRI reaches a certain value, it can meet our requirements for lamps. But CCT will affect the light directly. Halogen lamps generally have only one color temperature, the color temperature is about 2700K, and the light is yellowish. The LED can be chosen at will within 3000-6500K. In comparison, LEDs are more selective and more flexible.
The light distribution of the lamp mainly lies in its beam angle. The greater the beam angle of the lamp with the same power, the smaller the central light intensity, and the larger the illuminated area, the softer the spot will be; on the contrary, the smaller the beam angle, the greater the central light intensity, but the smaller the illuminated area, The light spot comes out harder.
The light distribution angle of the halogen lamp is very small, and the common ones are 10 degrees, 24 degrees, and 38 degrees. The LED light uses a lens to control the light beam angle, so its light distribution has great selectivity. From 15 degrees to 120 degrees, there are many options available.
LED does not need to be preheated, and can generally respond within tens of milliseconds, so it is a high-speed device, which is beyond the reach of other light sources. It can be achieved because the direct conversion of electricity to light.
The stroboscopic appearance of led lamps is related to the driver. If it is a good quality LED lamp, the driver uses a constant current circuit, the LED light is very stable, and there will be no stroboscopic. The flicker rate of LED lighting is 0.35%, which means that it can meet the requirements of real-time and delayed video broadcasting.
LED lights are directly converted into electricity by using semiconductor materials, which have higher luminous efficiency. Under the same lighting effect, the power of LED lamps is smaller, and it saves electricity, so as to achieve the effect of energy-saving.
The lifespan of LED lights is longer than that of halogen light and HID light. Under normal circumstances, the working life of LED lights can reach 50,000 to 80,000 hours or even 100,000 hours.
The CCT and lighting distribution can be changed easily because choice and customization of the led chips and beam angle can be available. The CCT can be an option from 3000K to 6500K, which is very good for a variety of applications and requirements. And lighting distribution has many solutions for your options, its beam angle also can be customized if it isn’t suitable for your need.
The LED lamp has high luminous efficiency, a wide illumination area, and soft lighting, which can meet the needs of professional competition and training lighting. Compared with the traditional halogen lamp, the illuminance is more uniform, the brightness is brighter, and the lamp has no glare and stroboscopic effects, ensuring the TV broadcast effect and improving the viewer's visual experience.
Halogen lamps are very energy-efficient devices, but they are far from invincible. What should you do if one of them fails? Of course, you went out and fixed the replacement bulb. If factors such as power management, heat management, and lens quality become difficult to handle, then you can simplify the process by choosing the following LED lights to replace halogen lamps.
New arrival 600W LED stadium light is designed for the applications that need high power light but doesn’t have enough to install too large led lighting fixture. It can replace 1500w halogen lamps directly.
Features:
• The series led lights has various of beam angles for your options yet: 15 / 30 / 45 / 60 degree. More degrees are still in development.
• Unique air convection radiator is designed for improving the heat dissipation, which can achieve 17 level wind resistance.
• Various mounting brackets are available: 360degree rotating bracket, round pole bracket, U-bracket. You can find the suitable mounting bracket with the need.
• The 600W led stadium light can install laser sight to increase the efficient of installation.
LED high mast light is the first choice of LED lighting fixture to replace halogen lamps in sports fields. That design is from halogen lamps.
Features:
• This series of led light are designed from 120watt to 1300watt. In one field, you can take multiple wattages to achieve the required light distribution scheme.
• The light has various beam angle 20 / 30 / 45 degree available. And narrow beam angle can be suitable for long-distance installation in sports venues with high light poles.
• Modular design allows us to install the power supply separately. With that installation, the wiring and maintenance will be easy.
B series led street light is the best replacement solution in road led lighting. The beautiful streamline design can be well integrated into the city and can add style to the city.
Features:
• Various wattages are available from 45watts / 75watts to 300watts.
• Especial beam angles that suitable for road lighting are for your options. You can choose between two lanes, three lanes or four lanes according to your needs.
• Tool-free led driver replacement and buckle design are good for later maintenance.
• Bubble level can help you save many cost in installation. Because it can improve the speed of installation.
• Automatic power-off device when open can provide better safety for maintenance personnel.
When the weight of led light has the strict requirements, C series led street light is the best option. Compared with other street lights, its size and weight are smaller without reducing the luminous efficacy.
Features:
• Minimalist and toughness design bring modern visual effect, angular appearance for lamp, and save the cost for installation and shipping.
• Various beam angles can be available, and the lens can achieve 92% transmittance.
• It can be connecting the solar panel for making the solar led lights. It is the best option for making smart city cctv system.
Parking lot led light is one of flood lights, it is not only used for parking lot light, but also can be used for wall pack light, wall washing light, small size basketball court and so on.
Features:
• This series of led light is from 100watt to 300watt.
• Snap-in power cover is easier and faster to install. Overall, its can achieve 10 seconds installation.
• Various of installation brackets are suitable for many kinds of installing poles.
C series led parking lot light is improving on the basis of B series parking lot light.
Features:
• Its wattage is from 75W to 280W. The mini wattage is 75W, not 100W.
• Split heat dissipation design reduce the lighting decay of LEDs effectively.
• Anti-bird and leaves design can better integrate the lamps with the natural environment. Without affecting the birds and the environment, the use effect of the lamp is improved.
• For increasing the lighting lifespan, the power box is designed with fin separately.
For indoor led lighting fixture, K2 series linear high bay light can be available for replacing the halogen lamps.
Features:
• Multiple wattages are available from 100w to 500w. You can choose the wattage suitable for your need.
• Beam angle 60 / 90 / 120degree can be provided, and transparent lens and frosted PC lens are both available.
• For its CCT, you can choose from 3000K to 6500K. If need other CCT, customized service are offered.
If you need high efficient linear high bay light with light weight, K5 linear high bay is a good option.
Features:
• The weight and thickness of led lights are improved without reducing the luminous efficacy.
• Snap-in type lens is helpful for the installation.
• This light support a variety of intelligent controls such as daylight sensor, motion sensor, Zigbee control and so on.
After reading the article, are you still wondering whether to use halogen bulbs or LED lighting fixture? We hope it can solve the questions about that.
Most stadiums and lighting venues have replaced traditional lamps with LED lights. Now LED lights have become the first choice for lighting fixtures in gymnasiums, roads and parking lots. If you want to know more information, you can contact our customer service staff. Professional and enthusiastic sales engineers are ready to serve you.
Author 2024-10-21
Hishine took part in the 136th canton lighting fair from 15th-19th October 2024. We met friends and clients from all around the world. Hishine has had a very happy 5-days in the canton fair.Hishie bro...
Author 2024-09-27
Hishine Group Limited is pleased to announce our participation in the Hong Kong International Outdoor and Tech Light Expo, and we invite all industry professionals, exhibitors, buyers, telecom operato...
